Hondata K Pro Australia ECU Removal

Hondata K Pro Australia ECU Removal & Identification

Removal

You will require the following tools

Philips screwdriver
10 mm socket and drive

Removal of your ECU from the passenger kick panel

The ECU is located in the passenger's footwell. The kickpanel is removed after depressing the centres of three small plastic buttons around the front covering panel.

Unplug the three wiring connectors and remove the two front most 10mm locating bolts. Loosen the rear 10mm bolt but do not remove it. The ECU will slide out.

Identification

Identification of the Oki processor, labelled (1) in the below picture.
The identification marks are very hard to read, and you might need to shine a bright light onto the surface mount processor to read the required information.

It should read along the lines of

Oki Japan
505
L66592 – 1252216 G2 or L66Q592 - 2131443 G2

Identification of the product label PRB number as listed on the white sticker on the ECU plugs

Example
37820 PRB Q01
2069 100252 3H3O

Other Useful Information

Year the car was made (Look on the VIN plates under the bonnet for this information)

Estimated purchase date

Please forward the above information to james@hondata.com.au to see if your ECU is compatible with Hondata K Pro without further modifcations.